External - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
E
S 6
XTERNAL
ECTION
6.1
System Hardware Manual
The PGD Adapter provides amplifiers for each page
output port (for a maximum of +8 dBM, 600 ohms at
1KHz). No additional page amplification is provided
by the PGD Adapter but, if required, an external
page amplifier can be used for additional
amplification.
The page output of the CD-CP00 does not provide
amplification (for a maximum output of -3 dBm, 600
ohms at 1KHz). If the paging volume is not
satisfactory using the CN8 or CN9 connector on the
CD-CP00, the PGD Adapter should be used instead.
P
AGING AND
External Page Relays
Two external dry contact relays are available when an PGD Adapter is
installed which can be used to activate ancillary devices (i.e. door unlock
devices). The CD-CP00 also provides one page relay. When the relay on the
PGD Adapter is used, there is no need to assign the relay to the Door Box –
connect the relay as detailed in the steps below for the Door Box used. The
relays on the PGD Adapters are numbered 5~8. Each Door Box/external page
circuit provides a dry relay contact.
If Relays 5 and 6 of a PGD Adapter are set as General

Purpose Relays, they cannot be used for Door Box/Page
Relays.
Program 10-21-05 sets the relay switch on the CD-CP00.

If General Purpose Relay is set to 1 (Relay 1), the page

relay cannot function on the CD-CP00. General
Purpose Relays override Paging Relays and the Paging
Relay is associated with Relay 1 on CN10.
The service codes indicated are the default codes. Refer

to Program 11-12-20 and 11-12-50 to redefine these
codes as needed.
D B /P
OOR OX AGE
Issue 9.0
R
ELAYS
7 - 17