Chsgw Small Batt Box Fuse Replacement; Figure 3-105 Removing The Chsgw Small Batt Box - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
6. To power on the 9.5" chassis, refer to
Up the SV8100 System on page
7.3.3

CHSGW SMALL BATT BOX Fuse Replacement

1. Correct the issue which caused the fuse problem.
Replacing fuses without first correcting the issue could cause a fire and/

or electric shock hazard.
2. Disconnect AC power cable from rear of chassis.
Make sure to unplug the unit from the electrical outlet prior to removing

the connection cables in the battery box unit.
3. Unplug all the cable connectors from the battery box.

Figure 3-105 Removing the CHSGW SMALL BATT BOX

4. Loosen the two thumb screws on the battery box and remove
the box by pulling on the two thumb screws.
5. Replace the fuse(s) as needed.
6. Replace the battery box and tighten the thumb screw on either
side of the box.
Only replace fuses of the same rating.

Fuses may be hot, use caution when replacing

them.
Issue 9.0
Chapter 4, 2.6 Powering
4-8.
3 - 77