Installation - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4 - 46
3.6.3

Installation

The MGN-U13 ETU board requires the CD-CP00, PZ-ME50 and
PZ-BS10 to be installed in the controlling CHS2U.
1. Install MGN-U13 ETU into IPK/IPK II CPU/EXP slot.
2. Install PZ-BS10 into the expansion slot in the SV8100.
3. Connect the CAT 5 cables between CN5~CN7 on the
MGN-U13 ETU to CN2~CN4 on the PZ-BS10.
4. Power on the IPK/IPK II KSU.
5. Power on the SV8100 main chassis and allow it to boot
completely. Allow the green FS1~3_ACT lights on the
MGN-U10 to come on steady, and wait for the red live light to
begin flashing.
6. Make programming changes as necessary.
Do not install or remove this board with the IPK/
IPK II cabinet power on.
The SV8100 should be at default state. Any
non-supported IPK II boards should be removed
at this time. Refer to
Hardware on page 4-47.
Do not plug the CAT5 cables in to any other

interface i.e. DLCA as serious damage
could occur.
Ensure the CAT 5 LAN cable is connected

between CN5~CN7 on the MGN-U13 ETU
to CN2~CN4 on the PZ-BS10.
IPK/IPK II PCPro data does not upload to a
migration package.
UNIVERGE SV8100
Table 4-18 IPK II Supported
Installing the SV8100 Blades