Installation; Figure 4-38 Pri Layout For Nt-1 Network - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
5.6.2

Installation

To install the CD-PRTA:
1. Plug the CD-PRTA into any universal slot in the chassis.
2. Use Program 10-51-01 (PRI/T1/E1) to set the CD-PRTA blade
to either PRI or T1 or E1.
3. Connect the cable from the NT1 Network Termination cable to
the CN2 connector on the CD-PRTA.
for NT-1 Network on page 4-91

Figure 4-38 PRI Layout for NT-1 Network

With normal operation, LED 1 flashes green.
is a cabling diagram.)
The NT1 connects to the network through

an 8-pin RJ-45/RJ48C connector. Use
either the RJ48C plug-to-RJ48C plug,
which ships with the NT1 or a RJ-45/48C
plug-to RJ-45/48C plug straight through
or CAT5 cable to connect the T1 to the
NT1. (Refer to Table 4-47 CD-PRTA
RJ48C Connector Pin-outs on page
With PRI Networking, a crossover cable

must be used on the master system PRI/
T1/E1 blade or NT1 to the telco
demarcation. If the systems are networked
side by side and not through telco, a
straight-through cable is used.
Issue 9.0
Figure 4-38 PRI Layout
4-95.)
4 - 91