Outside Lines; Table 4-55 Mdf Cable Connections (Trunk) - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
Connector
6
4 - 124
Table 4-55 MDF Cable Connections (Trunk) (Continued)
MDF Station
Running
Pin Cable
Cable
No. DTL
46 VI–BL GN
21 BL–VI RD
47 VI–OR GN
22 OR–VI RD
48 VI–GN GN
23 GN–VI RD
49 VI–BR GN
24 BR–VI RD
50 – –
25 – –
7.3.2

Outside Lines

An RJ-61 connector is authorized for connection of CO lines. The
lines are connected in sequence in this termination block. Therefore,
the lines must be ordered in the appearance order best suited to the
user. Refer to
4-121 or
for information about the MDF Connector Assembly Cable positions,
the cable number, and lead functions.
Loop Start, Loop Dial, DID(OT Only), E&M Tie lines, and E1(OT
Only) trunks can be connected to this system. Using only twisted-pair
wiring to cross connect the lines from the RJ-61 termination block to
the MDF is recommended.
COTB DIOPA
4 8 DID
T T T
R R R
T T T
R R R
T T T
R R R
T T T
R R R
– – –
– – –
Table 4-54 MDF Cable Connections (Station) on page
Table 4-55 MDF Cable Connections (Trunk) on page 4-123
UNIVERGE SV8100
PRTA
OPX PRI T1
T RA RA
R RB RB
T – –
R TA TA
T TB TB
R – –
T – –
R – –
– – –
– – –
Installing the SV8100 Blades
BRIA CCTA
TA–1 RA
TB–1 RB
RA–1 –
RB–1 TA
TA–2 TB
TB–2 –
RA–2 –
RB–2 –
– –
– –