Installation; Table 4-15 Iplb Codec Settings For Dsp Limitations - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4 - 36
Refer to the following tables for maximum upgrade capacities of the
PZ-32IPLB PZ-64IPLB
/
Table 2-4 9.5" Gateway and 19" Maximum System Capacities –

Chassis on page 2-11
When installing an IPLB daughter board, the system allocates the
maximum number of trunk ports for the blade being installed.
When the IPLB is installed, the remaining seven IP address entries should be

set to 0.0.0.0 in Program 84-26.
The IPLB does not have any DSP limitations based on CODEC
settings, (refer to
Limitations).

Table 4-15 IPLB Codec Settings for DSP Limitations

PZ-32
Codec
Baseline
G.711 32
G.722 32
G.726 32
G.729ab 32
G.723.1 32
iLBC 32
T.38 UDPL 32
T.38 RTP 32
3.5.2

Installation

To install a PZ-32IPLB/PZ-64IPLB/PZ-128IPLB on the CD-CP00:
Do not remove or install the CD-CP00 with the
power on.
PZ-IPLB does NOT WORK with R5 or lower
version of SV8100 main software.
When install PZ-xxIPLB to R6 or higher system first
time, F/W upgrade to PZ-xxIPLB will happen and the
system takes few minutes to boot up.
PZ-128IPLB daughter board:
/
Table 4-15 IPLB Codec Settings for DSP
PZ-64
w/SRTP Baseline w/SRTP
32 64
32 64
32 64
32 64
32 64
32 64
32 64
32 64
UNIVERGE SV8100
PZ-128
Baseline w/SRTP
64 128 128
64 128 128
64 128 128
64 128 128
64 108 96
64 128 128
64 128 128
64 128 128
Installing the SV8100 Blades