Led Indications; Table 4-6 Cd-Cp00 Switch 6 Settings; Table 4-7 Cd-Cp00 Led Indications - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
SW6-1
SW6-2
SW6-3
SW6-4
RUN (LED1)
4 - 20
Configuration
ON
OFF
OFF
ON
3.1.4

LED Indications

The LEDs on the CD-CP00 indicate the following:
RUN (LED 1) = The CPU is operating (green)

LED 2, and 3 = Alarms (red)

LED 4 = Flash access indication (red)

LED 5 = The USB memory connection status (red)

(LED off when no USB memory installed)
Refer to Program 90-10: System Alarm Setup for details on assigning

alarm LEDs.

Table 4-7 CD-CP00 LED Indications

associated operation and status indications. Refer to
CD-CP00 Blade Layout on page 4-14
the CD-CP00.
LED Indication
LED2 LED3
Blinking Off
Off Off

Table 4-6 CD-CP00 Switch 6 Settings

A-law/-law Mode Select
Test Mode
RS232C Select
Reset Configuration
Table 4-7 CD-CP00 LED Indications
LED4 LED5
Off Off On Steady When
USB Memory is
Installing
Off Off Blinking
UNIVERGE SV8100
Note
OFF = 1.5M PRI (-law)
ON = 2M PRI (A-law) <default>
ON = Test Mode
OFF = Normal
ON = Use
OFF = Not Used
ON = Normal
OFF = ICE Mode
provides a list of each LED and
Figure 4-5
for the location of the LEDs on
Status
System operating normally
Boot is starting
Installing the SV8100 Blades