Issue 9.0
ESI
ETU
9 - 24
Figure 9-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit
(Example)
shows how the CT(U)-R Unit is connected to the ESI(8)-U( ) ETU
and to the PC. The required AC-2R/AC-3R/ACA-UA Unit is not shown.
Multiline Terminal + CT(U)-R Unit
Line Cord (2-line)
Figure 9-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit (Example)
3.5.1
Installing the CT(U)-R Unit
The CT(U)-R Unit should be installed after the switches are set.
When wall mounting the multiline terminal, a WM-R Unit must be used.
Refer to
1.
Prepare the multiline terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page
2.
Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to
Multiline Terminal on page
CT(U)-R Unit
Optional Headset
Section 11 Wall Mounting Multiline Terminals on page
9-1.
Figure 9-26 Attaching the CT(U)-R Unit to the
9-25.
Installing D
UNIVERGE SV8100
USB Cable
term
Series i Optional Equipment
PC
8-22.