Switch Settings; Table 4-5 Cd-Cp00 Switch Settings - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
2. Refer to
Installed on page 4-15
PZ-32/64/128 IPLA or PZ-32/64/128 IPLB daughter board, if
required.
3. Ensure the power supply is OFF, then slide the CD-CP00 into
Slot 1 in the Controlling Chassis.
4. If external Background Music (BGM) or Music on Hold (MOH)
is being installed, plug the cable into the CN8 or CN9 pin jack
connector on the CD-CP00. The other end of the cable plugs
into the music source.



3.1.3

Switch Settings

Refer to

Table 4-5 CD-CP00 Switch Settings

system reset and with system power on.
Layout on page 4-14
CD-CP00 blade.
USB Memory Status
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Switch
SW1 – Load
When USB Memory is
Switch
installed:
When an unauthorized USB
device is installed:
Figure 4-6 CD-CP00 Blade with Daughter Boards
to Install the PZ-VM21, PZ-ME50 and/or
Refer to the PGD ADAPTER in the
Optional Equipment section
7-1 for details on connecting to a music source.
When the system software is upgraded, the flash memory is
updated with the new software version. Either the Hot or Cold
start-up method can be used or the system can be upgraded
using system software. Refer to
on page 4-8, 2.6.2 Performing a Hot Start on page
Performing a Software Upgrade on page
Customer information is stored in the RAM memory which is
restored after a power failure is cleared. The lithium battery in
the system saves the RAM memory when power is lost.
shows the location of the SW1 switch on the
Table 4-5 CD-CP00 Switch Settings
Chapter 7 Installing SV8100
2.1 Using a PGD Adapter on page
2.6.1 Performing a Cold Start
4-12.
for system restart/
Figure 4-5 CD-CP00 Blade
Operation
Cold Start occurs.
Database default occurs

USB Memory contents loaded.
System does not start and an Illegal
USB device is connected alarm is
recorded.
Issue 9.0
4-9, or 2.6.4
4 - 19