Figure 9-21 Attaching The Ct(A)-R Unit To The Terminal - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
9 - 20
3.4.1 Installing the CT(A)-R Unit
The CT(A)-R Unit should be installed before connecting the PC and
before connecting the ESI port to the multiline terminal.
When wall mounting the multiline terminal, a WM-R Unit must be used.

Refer to
1. Prepare multiline terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page
2. Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to
Terminal on page
Section 11 Wall Mounting Multiline Terminals on page
9-1.
Figure 9-21 Attaching the CT(A)-R Unit to the
9-21.
Installing D
UNIVERGE SV8100
term
Series i Optional Equipment
8-22.