Connectors; Table 4-32 Pz-4Lca/Pz-8Lce/ Rj-61 Cable Connector Pin-Outs - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
To install the PZ-4LCA
1. Four plastic spacers are Included with the PZ-4LCA/PZ-8LCE.
Install the plastic spacers on either the CD-4LCA or CD-8LCA.
Make sure to attach the spacers so that they extend out on the
side of the daughter board which has the CN1 connector.
Refer to
page 4-64
Board on page
2. Position the PZ-4LCA
connector on the CD-4LCA/CD-8LCA blade. Press the blade
and board together, ensuring the plastic spacers lock in place.
Refer to
page 4-64
Board on page
3. Install the CD-4LCA/CD-8LCA blade in the slot in the chassis.
4.4.3

Connectors

Table 4-32 PZ-4LCA/PZ-8LCE/ RJ-61 Cable Connector Pin-Outs

show the pin-outs for the RJ-61 connector.
PZ-4LCA Daughter Board on page 4-64
the PZ-8LCE Daughter Board on page 4-65
connectors on the PZ-4LCA
Table 4-32
PZ-8LCE – CN2 (ports 9~12), CN3 (ports 13~16)
/ :
PZ-8LCE
Figure 4-29 Installing the PZ-4LCA Daughter Board on
and Figure 4-30 Installing the PZ-8LCE Daughter
4-65.
/
PZ-8LCE CN1 connector over the CN4
Figure 4-29 Installing the PZ-4LCA Daughter Board on
and Figure 4-30 Installing the PZ-8LCE Daughter
4-65.
/
PZ-8LCE daughter boards.
PZ-4LCA/PZ-8LCE/ RJ-61 Cable Connector Pin-Outs
RJ-61 Cable Connector –
PZ-4LCA – CN2 (ports 9~12)
Pin No.
Figure 4-29 Installing the
and Figure 4-30 Installing
show the location of the
Connection
1 T4 (Tip for port 4)
2 T3 (Tip for port 3)
3 T2 (Tip for port 2)
4 R1 (Ring for port 1)
5 T1 (Tip for port 1)
6 R2 (Ring for port 2)
7 R3 (Ring for port 3)
8 R4 (Ring for port 4)
Issue 9.0
4 - 67