Led Indications; Active Led - Green; Figure 4-45 Install The So-Dimm Memory; Figure 4-46 Install The Compact Flash Drive - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4 - 104
5. Install the Compact Flash drive into slot CN7, make sure the
drive is fully seated in the slot (refer to
Compact Flash
6.1.3

LED Indications

6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.





Figure 4-45 Install the SO-DIMM Memory

Drive).

Figure 4-46 Install the Compact Flash Drive

Off: Power off.
On: Reset.
Slow Flash: Board is running but not in sync with the
chassis yet.
Fast Flash: Board is in sync with the chassis and
operating normally.
UNIVERGE SV8100
Figure 4-46 Install the
Installing the SV8100 Blades