Installing The Ada-L Unit; Figure 7-24 Separate Tilt Leg From Leg Support - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
7 - 34
10.3.2

Installing the ADA-L UNIT

Perform the following steps to connect the ADA-L UNIT to the
Bottom Option Interface located underneath the DTL/ITL multiline
terminal.
Only one ADA-L UNIT can be installed at a time.

1. Unplug the line cord from the multiline terminal.
2. Turn the DTL/ITL multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg Support on page
Tilt Leg
4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout on page
To prevent possible damage to the ADA-L UNIT
or the DTL/ITL multiline terminal during
installation or removal, disconnect the line
cord/LAN cable and the AC/DC adapter from
the DTL/ITL multiline terminal.

Figure 7-24 Separate Tilt Leg from Leg Support

Figure 7-25 Bottom Option Interface
7-35).
Installing SV8100 Optional Equipment
UNIVERGE SV8100
Figure 7-24
7-34).
Stoppers