Checking The Configuration; Configuration Examples; Example For Configuring A Css - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
The system view is displayed.
Step 2 Run:
css enable
The CSS function is enabled.By default, the CSS function is disabled on a device.
----End

2.3.5 Checking the Configuration

After a CSS is set up, you can view the frame ID, priority, and CSS status of each member
switch, and whether the CSS function is enabled.
Prerequisite
CSS configurations of the S9300 are complete.
Procedure
Step 1 Run the display css status [ save ] [ all | frame frame-id ] command to check the CSS
information.
----End
Example
<Quidway> display css status
Property Item
Frame ID
Priority
Enable switch
CSS master force
CSS status

2.4 Configuration Examples

This section provides a CSS configuration example.

2.4.1 Example for Configuring a CSS

You can configure the CSS function to improve the capacity and reliability of devices.
Networking Requirements
As shown in
is connected to the CSS through Eth-Trunk 1. The CSS is connected to an OSPF network through
Eth-Trunk 2. The CSS improves the capacity and reliability of switches.
Issue 03 (2011-12-29)
NOTE
The configuration takes effect after the device is restarted.
Figure 2-3, SwitchA and SwitchB form a CSS. SwitchC is a user-side device and
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Property Value
1
255
On
Off
master
2 CSS Configuration
20