Outputting Debugging Information To The Log Host - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
2.
3.
Step 3 Enabling Terminal Display
1.
2.
----End

5.5.7 Outputting Debugging Information to the Log Host

By outputting debugging messages to the log host, you can view debugging messages more
conveniently.
Procedure
Step 1 Configuring Debugging Information to be output through the Channel
1.
2.
Step 2 Configuring the Channel through which debugging information is output to the Log Host
l (On an IPv4 network) Run:
l (On an IPv6 network) Run:
Issue 03 (2011-12-29)
Run:
info-center monitor channel { channel-number | channel-name }
The channel through which debugging information is output to the terminal is configured.
Run:
quit
Back to the user view.
Run:
terminal monitor
Terminal display is enabled.
Run:
terminal debugging
Displaying debugging information on the terminal is enabled.
Run:
system-view
The system view is displayed.
Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ debug { state { off | on } | level severity }
Debugging information is added to the information channel.
info-center loghost ip-address [ channel { channel-number | channel-name } |
facility local-number |
{ language language-name | binary [ port ] } | { vpn-instance vpn-instance-
name| public-net } ]
The channel through which debugging information is output to the log host is configured.
By default, debugging information is not output to the log host after the information center
is enabled.
The system supports the configuration of a maximum of eight log hosts to realize backup
among log hosts.
info-center loghost ipv6 ipv6-address [ channel { channel-number | channel-
name } | facility local-number | { language language-name | binary [ port ] } ]
*
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
5 Information Center Configuration
*
]
78