Configuration Examples - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Procedure
Step 1 Run the display poe-power command to view the status of the PoE power supply.
Step 2 Run the display poe device command to view information about the devices that support the
PoE function.
Step 3 Run the display poe information command to view the PoE information.
Step 4 Run the display poe power interface interface-type interface-number command to view the
output power of an interface.
Step 5 Run the display poe power slot slot-id command to view the output power of the interfaces on
the board in the specified slot.
Step 6 Run the display poe power-state interface interface-type interface-number command to view
the status of PoE power supply on an interface.
Step 7 Run the display poe power-state slot slot-id command to view the status of PoE power supply
on the board in the specified slot.
----End

7.4 Configuration Examples

This section provides an example of PoE power supply.
Networking Requirements
As shown in
l
l
l
l
l
l
Issue 03 (2011-12-29)
Figure 7-1, the requirements as follows:
PoE boards are installed in slot 1 and slot 2 of the S9306, and the PoE power supply is
installed.
IP phones are connected to GigabitEthernet 1/0/1 and GigabitEthernet 2/0/1.
Other PDs are connected to GigabitEthernet 1/0/2 and GigabitEthernet 2/0/2.
The PD connected to GigabitEthernet 1/0/2 has a high priority in power supply.
The maximum output power of the PoE board in slot 1 is 200 W.
The PD connected to GigabitEthernet 2/0/2 requires the input power of no more than 20
mW.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PoE Power Supply Configuration
127