Huawei Quidway S9300 Configuration Manual page 102

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Figure 5-7 Example for Configuring Binary Logs to be sent to the Log Host
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need to perform the following data:
l
l
l
l
l
Procedure
Step 1 Configure routes between Switch A and Loghost. (The detailed procedure is not mentioned here.)
Step 2 Enable the information center.
# Enable the information center.
<Quidway> system-view
[Quidway] info-center enable
Step 3 Add the ID of a log to be filtered.
# Configure the module and channel used to output alarm messages.
[Quidway] info-center filter-id 1077514264
Step 4 Generate a data dictionary and send it to the log server.
# Configure alarm messages to be output to the SNMP agent.
[Quidway] info-center create-logbook ftp 10.1.1.6 user-name ftp password ftp file-
name dicx.xml
After the data dictionary is sent successfully, a prompt is displayed indicating Info: Succeeded
in creating a data dictionary.. For further confirmation, you can check whether the data
dictionary is successfully sent to the log server.
Issue 03 (2011-12-29)
GE1/0/1
10.1.1.1/24
Enable the information center on the switch.
Add the ID of a log to be filtered.
Generate a data dictionary and send it to the log server.
Configure binary logs to be sent to the log host.
ID of the log to be filtered
File name of the generated data dictionary
IP address of the FTP server
User name and password used for logging into the FTP server
IP address of the log host
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loghost
10.1.1.6/24
5 Information Center Configuration
90