Huawei Quidway S9300 Configuration Manual page 16

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l
Issue 03 (2011-12-29)
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
nap port master
The NAP Master interface is configured and started.
Manual IP address allocation
Two methods are available for manually allocating IP addresses. You can choose the
method according to actual needs.
You can specify the NAP IP address pool. Then, IP addresses are automatically allocated
to the IP address pool. To use this method, do as follows.
1. Run:
system-view
The system view is displayed.
2. Run:
nap ip-pool ip-address mask-length
An IP address pool is configured for NAP.
The default IP address pool for establishing NAP connections is 10.167.253.0/24. You
can run the nap ip-pool ip-address mask-length command to change the IP address
pool.
NOTE
After NAP is started on the master device, the IP address pool cannot be changed.
3. Run:
interface interface-type interface-number
The interface view is displayed.
4. Run:
nap port master
The NAP Master interface is configured and started.
You can also specify the NAP IP addresses. To use this method, do as follows.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
nap port master
The NAP master interface is configured and started.
4. Run:
nap local-ip mast-inter-mast-ip sub-ip mast-inter-sub-ip peer-ip sub-
inter-mast-ip sub-ip sub-inter-sub-ip mask-length
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 NAP Configuration
4