Huawei Quidway S9300 Configuration Manual page 95

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Figure 5-5 Networking diagram of outputting logs to the log host
10.2.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Procedure
Step 1 Configure routing protocols to make the switch and log server routable. (The detailed procedure
is not mentioned here.)
Step 2 Configure the channel for outputting logs.
# Enable the information center.
<Quidway> system-view
[Quidway] info-center enable
Step 3 Name the channel.
# Name the channel through which logs are output.
Issue 03 (2011-12-29)
10.1.1.2/24 10.1.1.1/24
Server1
Server 3
Server 4
Server 2
10.2.1.1/24
Enable the information center.
Name the tunnel.
Specify the module enabled to output logs.
Configure the channel for outputting logs.
Configure the source interface that sends logs.
Configure the log host.
IP address of the log host
Information channel number
Name of the channel through which logs are output
Module enabled to output logs
Information severity level
Language in which the log is output
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/1
172.168.0.1/24
Switch
5 Information Center Configuration
83