Huawei Quidway S9300 Configuration Manual page 93

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Configure the routing protocol to make the switch and the FTP server reachable. (The detailed
procedure is not mentioned here.)
Step 2 Configure user name and password used on the FTP server. (The configuration details are not
provided here.)
Step 3 Configure the channel used to output logs.
# Enable the information center.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] info-center enable
Step 4 Configure the logs to be output through the channel.
# Configure the module enabled to output logs and the severity levels of logs allowed to be
output.
[SwitchA] info-center source ip channel channel9 log level warnings
Step 5 Configure the channel through which logs are output.
# Configure the channel through which logs are output to the log file.
[SwitchA] info-center logfile channel channel9
[SwitchA] quit
Step 6 Set logs to be output to the FTP server.
# Log in to the FTP server.
<SwitchA> ftp 10.1.1.1
Issue 03 (2011-12-29)
Enable the information center.
Configure the contents of the logs to be output.
Configure the channel through which logs are output.
Set logs to be output to the FTP server.
IP address of each interface
Information channel number
Module enabled to output logs
Severity levels of logs
Language in which logs are output
IP address of the FTP server
User name and password of the FTP server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Information Center Configuration
81