Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l
l
----End

7.3.4 Checking the Configuration

After the PoE configurations are complete, you can view the PoE power status, device
information, and PoE configuration on an interface.
Prerequisite
The PoE power supply and PoE board are installed, and the PoE function is configured.
Issue 03 (2011-12-29)
NOTE
When the manual power management mode is adopted, you must manually power on or power
off PDs on interfaces.
Optional: Setting the power-off time range of a PoE interface
1. Run:
system-view
The system view is displayed.
2. Run:
time-range time-name { start-time to end-time days | from time1 date1
[ to time2 date2 ] }
The power-off time range of a PoE interface is set.
3. Run:
interface interface-type interface-number
The interface view is displayed.
4. Run:
poe power-off time-range time-name
The power-off time range takes effect on the interface.
Optional: Enabling an interface to check compatibility of PDs
NOTE
Before enabling an interface to check compatibility of PDs, you must enable PoE on the PSE. After
this function is enabled, the interface can detect the PDs that do not comply with IEEE 802.3af or
802.3at.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
poe legacy enable
The interface is enabled to check compatibility of PDs.
By default, an interface does not check compatibility of PDs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PoE Power Supply Configuration
126