Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Context
Be cautious to use the schedule reboot command because it can break down the whole network
for a short period of time.
Before you run the schedule reboot command to reboot the S9300 on schedule, check whether
configuration files need be saved and ensure that correct files are used for rebooting the
S9300. For details on saving configuration files, see the Quidway S9300 Terabit Routing Switch
Configuration Guide - Basic Configuration.
Do as follows on the S9300 that needs to be rebooted on schedule:
Procedure
Step 1 Run:
schedule reboot { at exact-time | delay interval }
On-schedule reboot is configured. You can specify the time for rebooting theS9300 by setting
type.
l at time: specifies the specific time for rebooting the S9300.
l delay interval: specifies the waiting time before rebooting the S9300.
By default, this command can only be run by users at the management level. By default, the time
for rebooting the S9300 is not set. That is, on-schedule reboot is not enabled.
----End

9.4.5 Checking the Configuration

After using commands to reboot the S9300 on schedule, you can view information about on-
schedule reboot of the S9300.
Prerequisite
On-schedule reboot has been enabled through command lines.
Procedure
Step 1 Run the display schedule reboot command to check configurations about on-schedule reboot
of the S9300.
----End
Example
If information about on-schedule reboot of the S9300 is displayed, it means that the configuration
succeeds.
<Quidway> display schedule reboot
Info:System will reboot at 00:00:00 2007/10/30 (in 23 hours and 53 minutes).
Issue 03 (2011-12-29)
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Rebooting
148