Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
----End

10.3.5 Checking the Configuration

By viewing the value of the ISSU timer and the backup status, you can check whether the
configurations are successful.
Prerequisite
All configurations of ISSU are complete.
Procedure
l
l
l
l
l
l
l
l
----End
Example
Run the display issu timer rollback command to view the length of the ISSU rollback timer.
<Quidway> display issu timer rollback
The length of the rollback timer is 60 minutes. There are 31 minutes left.
Run the display issu module command to view the modules that supports ISSU.
<Quidway> display issu module
-----------------------------------------------------------
Slot
-----------------------------------------------------------
8
8
8
8
8
8
8
Issue 03 (2011-12-29)
NOTE
If you check the status of the AMB and SMB after the ISSU plane switch is complete, you can find that
the new AMB is still in the slave state. This is because the hardware switch has not finished yet. After you
run the issu confirm command to confirm the ISSU operation and the old AMB restarts with the new
version, check the status of the AMB and SMB. At this time, you can find that both ISSU plane switch and
hardware switch are complete and the status of the new AMB becomes Master.
Run the display issu timer rollback command to view the length of the ISSU rollback
timer.
Run the display issu module command to view the modules that supports ISSU.
Run the display issu check-result command to view the result of ISSU check.
Run the display issu backup state command to view the status of ISSU backup.
Run the display issu backup-result [ state { resource-prepare | backup-prepare |
backup1 | backup2 | backup3 | smooth | smooth-all-over } ] command to view the result
of ISSU backup.
Run the display issu recover-configuration command to view the commands that fail to
restore configurations.
Run the display issu switch-result { check | prepare | age } command to view the result
of ISSU switch check, switch preparation, and the cause of switch failure.
Run the display issu state command to view which ISSU phase the system passes.
ModuleId
0x41470000
0x40E90000
0x40E00000
0x41270000
0x416E0000
0x40A40000
0x400F0000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 ISSU Configuration
ModuleName
AAA
ND
FIB6
RPR
ARP
CHDLC
DHCPS
156