Configuration Examples; Example For Configuring Local Port Mirroring - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l
l
l
----End

6.6 Configuration Examples

This section provides several configuration examples of port mirroring and traffic mirroring.

6.6.1 Example for Configuring Local Port Mirroring

Networking Requirements
The R&D department and marketing department access the Switch through GE 1/0/1 and
GE1/0/2; a data detection device, that is, a server, is connected to GE 1/0/3 of the Switch. It is
required that the server should monitor sent packets of the R&D department and marketing
department through local port mirroring.
Figure 6-3 Networking diagram of local port mirroring configurations
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
Issue 03 (2011-12-29)
Run the display traffic classifier user-defined [ classifier-name ] command to check the
configuration of the traffic classifier.
Run the display traffic policy user-defined [ policy-name [ classifier classifier-name ] ]
command to check the configuration of the traffic policy.
Run the display traffic-policy policy-name applied-record command to check the
application of the traffic policy.
LSWA
R&D
department
LSWB
Marketing
department
Configure GE 1/0/3 as an observing port.
Configure GE 1/0/1 and GE 1/0/2 as mirrored ports.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 6-3 shows the networking diagram.
GE 1/0/1
GE 1/0/3
Switch
GE 1/0/2
6 Mirroring Configuration
Server
192.168.1.100
108