Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
clock force-switch source source { system | bits0 | bits1 }
A new reference clock source is forcibly specified for the system clock, BITS0 clock, or BITS1
clock.
l The number of the clock source for the system clock ranges from 0 to 8.
l The number of the clock source for the BITS clocks ranges from 5 to 9.
Table 11-2
Table 11-2 Mappings between the clock source numbers and clock sources
Clock No.
0
1
2
3
4
5
6
7
8
9
----End

11.3.3 Checking the Configuration

After forcibly specifying a reference clock source, you can check the configuration by using the
following commands.
Prerequisite
The configurations of forcible clock source selection are complete.
Procedure
Step 1 Run the display clock mode command to view the mode of clock source selection.
Issue 03 (2011-12-29)
shows the mappings between the clock source numbers and clock sources.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Ethernet Clock Syntonization Configuration
Clock Source
Inner Clock
BITS0
BITS1
Peer Board BITS0
Peer Board BITS1
Left Frame Clock
Right Frame Clock
FSU (reserved)
Peer Board FSU (reserved)
System Clock
168