Configuring Time Attributes For Ptp Packets; Configuring Encapsulation Types For Ptp Packets - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management

12.4.4 Configuring Time Attributes for PTP Packets

Procedure
l
l
----End

12.4.5 Configuring Encapsulation Types for PTP Packets

Issue 03 (2011-12-29)
Configuring time attributes for Announce packets
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. (Optional) Run:
ptp announce-interval announce-interval
The interval for sending Announce packets on an interface is set to the announce-
intervalth power of 2, in milliseconds.
The default value of announce-interval is 7, which means that the interval for sending
Announce packets on the interface is 128 ms.
4. (Optional) Run:
ptp announce-receipt-timeout timeout-value
The timeout period for receiving Announce packets on an interface is set to the nth
power of 2, in milliseconds, where n is specified by timeout-value.
The default timeout-time is 9, which means that the timeout period for receiving
Announce packets on the interface is 512 ms.
Configuring time attributes for Delay packets
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. (Optional) Run:
ptp min-req-interval interval-value
The interval for sending PdelayReq packets and DelayReq packets on an interface is
set to the interval-valueth power of 2, in milliseconds.
The default interval-value is 7, which means that the interval for sending PdelayReq
packets and DelayReq packets on the interface is 128 ms.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PTP Configuration
220