Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
----End

12.3.6 Checking the Configuration

Prerequisite
All configurations of OC1 and OC2 are complete.
Procedure
l
l
----End
Issue 03 (2011-12-29)
– For unicast UDP encapsulation
Specify the unicast destination IP address encapsulated in the 1588v2 packet in
the interface view.
– For multicast UDP encapsulation
A default multicast destination IP address is adopted, which means that
destination-ip destination-ip does not need to be configured. The default multicast
destination IP address varies with delay measurement mechanisms as shown in the
following table.
Packet Type
All except peer delay measurement
mechanisms
Peer delay measurement mechanism
NOTE
If the parameter destination-ip destination-ip is not configured, a multicast IP address is
adopted.
4. Run:
ptp udp-egress destination-mac destination-mac
The next hop MAC address of the 1588v2 packet is configured.
5. Run:
ptp udp-egress source-ip source-ip [ dscp dscp ]
The DSCP priority to be carried in the UDP-encapsulated 1588v2 packet is configured.
6. Run:
ptp udp-egress source-ip source-ip vlan vlan-id [ priority priority ]
The VLAN ID for sending 1588v2 packets and the priority of the UDP-encapsulated
1588v2 packet are configured on the interface.
Run the display ptp all [ state | config ] command to display the operation status and
configuration of 1588v2.
Run the display ptp interface interface-type interface-number command to display
1588v2 information of the interface on the 1588v2 device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PTP Configuration
IP Address
224.0.1.129
224.0.0.107
216