Outputting Alarms To The Log File; Outputting Alarms To The Console - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management

5.4.5 Outputting Alarms to the Log File

When a fault occurs on the device, you can analyze the output alarms to provide references for
fault location.
Context
Do as follows on the switch configured with the information center:
Procedure
Step 1 Run:
1.
2.
Step 2 Configuring the channel through which alarms are output to the log file
1.
Step 3 (Optional) Configuring the size of the log file output by the Information Center
1.
----End

5.4.6 Outputting Alarms to the Console

By outputting alarms to the console, you can view the operating status of the device on the
console.
Context
Do as follows on the switch configured with the information center:
Procedure
Step 1 Configuring the alarms to be output through the channel
1.
Issue 03 (2011-12-29)
Do as follows on the switch configured with the information center, run:
system-view
The system view is displayed.
Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ trap { state { off | on } | level severity }
Alarms are added to the information channel.
By default, the timestamp format of alarms is date.
Run:
info-center logfile channel { channel-number | channel-name }
The channel through which alarms are output to the log file is configured.
By default, alarms are output through Channel 9 to the log file after the information center
is enabled.
Run:
info-center logfile size size
By default, the size of log files is 8 M.
Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Information Center Configuration
*
]
69