Configuring Traffic Mirroring; Establishing The Configuration Task; Configuring An Observing Port - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l
----End

6.5 Configuring Traffic Mirroring

This section describes how to configure traffic mirroring.

6.5.1 Establishing the Configuration Task

Applicable Environment
To analyze or monitor the packets of the same attributes passing through an interface on the
S9300, you can configure traffic mirroring.
Pre-configuration Tasks
None
Data Preparation
To configure traffic mirroring, you need the following data.
No.
1
2
3

6.5.2 Configuring an Observing Port

Context
Do as follows on the S9300 where traffic mirroring needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the following command to configure an observing port as required.
l If an observing port is directly connected to a monitoring device, run:
l If the device where an observing port is located is connected to a monitoring device over a
Issue 03 (2011-12-29)
Run the display port-mirroring command to check the mirrored port in port mirroring.
Data
Type and number of the observing port
Type and number of the traffic mirrored port
Names of the traffic classifier and traffic behavior and rules in the traffic classifier
observe-port [ observe-port-index ] interface interface-type interface-number
Layer 2 network, run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Mirroring Configuration
104