Huawei Quidway S9300 Configuration Manual page 140

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Figure 7-1 Networking diagram of the PoE application
IP Phone
IP Phone
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 In the system view, set the maximum output power of the PoE board in slot 1.
# Set the maximum output power of the PoE board in slot 1 to 200 W.
<Quidway> system-view
[Quidway] poe max-power 200000 slot 1
Step 2 Set the maximum output power of GigabitEthernet 2/0/2.
<Quidway> system-view
[Quidway] interface gigabitethernet 2/0/2
[Quidway-GigabitEthernet2/0/2] poe power 20
[Quidway-GigabitEthernet2/0/2] quit
[Quidway]
Step 3 Set the power supply priority of GigabitEthernet 1/0/2 to critical.
Issue 03 (2011-12-29)
GE 1/0/1
GE 2/0/1 GE 2/0/2
In the system view, set the maximum output power of the PoE board in slot 1.
In the interface view, set the power supply priority of GigabitEthernet 1/0/2.
In the interface view, set the maximum output power of GigabitEthernet 2/0/2.
Power supply priority of GigabitEthernet 1/0/2
Maximum output power of the PoE board in slot 1
Maximum output power of GigabitEthernet 2/0/2
NOTE
On the S9300, the unit of the output power is mW.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE 1/0/2
PD
PD
7 PoE Power Supply Configuration
128