Huawei Quidway S9300 Configuration Manual page 104

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Networking Requirements
As shown in
transmitted to the NM Station through SNMP Agent.
Figure 5-8 Networking diagram of outputting alarms to the SNMP Agent
NM Station
10.1.1.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable the information center.
<Quidway> system-view
[Quidway] info-center enable
Step 2 Specify the module enabled to output alarms and configure the channel used to output alarms.
# Specify the module enabled to output alarms and configure the channel used to output alarms.
[Quidway] info-center source ip channel channel7 trap level informational state on
Step 3 Enable outputting alarms to the SNMP agent.
# Enable outputting alarms to the SNMP agent.
[Quidway] info-center snmp channel channel7
Step 4 Enable transmitting alarms to the NM Station through SNMP agent.
Issue 03 (2011-12-29)
Figure 5-8, alarms are required to be output first to the SNMP agent and then be
Enable the information center on the switch.
Specify the module enabled to output logs and configure the channel through which the
alarm is output.
Enable outputting alarm to the SNMP agent.
Enable transmitting alarms to the NM Station through SNMP.
Information channel number
Module enabled to output alarms
Severity levels of alarms
NOTE
By default, alarms are output through the SNMP agent and information about all modules is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/1
Agent
10.1.1.2/24
5 Information Center Configuration
92