Huawei Quidway S9300 Configuration Manual page 22

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Switch B and Switch C having an empty configuration. Switch B and Switch C need to be directly
connected via a single hop. Both the interfaces connecting Switch B and Switch C should be in
the Up state, and should support NAP.
Figure 1-2 Networking diagram of NAP-based remote deployment
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
None
Procedure
Step 1 Configuring the NAP master interface
# Do as follows on Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] interface gigabitethernet1/0/1
[SwitchB-GigabitEthernet1/0/1] nap port master
Step 2 Logging in to the slave device from the master device.
# Do as follows on Switch B.
[SwitchB-GigabitEthernet1/0/1] nap login neighbor
Trying 10.167.253.10 ...
Press CTRL+K to abort
Connected to 10.167.253.10 ...
Info: The max number of VTY users is 10, and the number
Step 3 Shutting down NAP on the slave device.
# Do as follows on Switch C.
<Quidway> system-view
[Quidway] sysname SwitchC
[SwitchC] undo nap slave enable
----End
Issue 03 (2011-12-29)
SwitchA
Configure a primary IP address and a secondary IP address on Switch B.
Configure a NAP master interface on Switch B.
Telnet to Switch C from Switch B by means of NAP.
of current VTY users on line is 1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Network
SwitchB
1 NAP Configuration
SwitchC
10