Huawei Quidway S9300 Configuration Manual page 207

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Freq-Check : No.
Retrieve
Hold Type
Run Mode
Bits0
Bits1
System mode: Auto select clock source 5: Left Frame Clock.
Bits0 mode : Auto select clock source 9: System Clock.
Bits1 mode : Auto select clock source 9: System Clock.
Clock time : Free-run
# Ensure that the system clock selects the clock source sent from the left side of the frame as the
clock source and that the system clock sends clock signal to the LPUs as the output clock signal.
[SwitchC] display clock selection
Type
---------------------------------------------------------------------
system
bits0
bits1
Step 4 Verify the configuration.
The commands used to verify the configuration result are included in the preceding steps.
----End
Configuration Files
l
l
l
Issue 03 (2011-12-29)
: Yes.
: Hold 24 hours.
: Trace.(SyncOK, Locked)
: Locked.
: Locked.
Configuration file of Switch A
#
sysname SwitchA
#
clock ql-enable
clock priority 1 source 1 system
#
Configuration file of Switch B
#
sysname SwitchB
#
clock ql-enable
clock priority 6 source 6 system
#
interface GigabitEthernet5/0/3
clock right-frame 20
#
interface GigabitEthernet5/0/7
clock right-frame 10
#
Configuration file of Switch C
#
sysname SwitchC
#
clock ql-enable
clock priority 5 source 5 system
#
interface GigabitEthernet2/0/0
clock left-frame 40
#
interface GigabitEthernet2/0/3
clock left-frame 30
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Ethernet Clock Syntonization Configuration
Clock Source Selected
5. Left Frame Clock
9. System Clock
9. System Clock
195