Huawei Quidway S9300 Configuration Manual page 227

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l
Issue 03 (2011-12-29)
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. (Optional) Run:
ptp mac-egress destination-mac destination-mac
The 1588v2 packets to be sent from the interface are encapsulated in MAC
encapsulation mode, and the destination MAC address is configured.
– For unicast MAC encapsulation
Specify the unicast destination MAC address encapsulated in the 1588v2 packet
in the interface view.
– For multicast MAC encapsulation
A default multicast destination MAC address is adopted, which means that
destination-MAC destination-MAC command does not need to be performed. The
default multicast destination MAC address varies with delay measurement
mechanisms as shown in the following table.
Packet Type
All except peer delay measurement
mechanisms
Peer delay measurement mechanism
NOTE
If the unicast destination MAC address is not configured, a multicast destination MAC address
is adopted by default.
4. Run:
ptp mac-egress vlan vlan-id [ priority priority-value ]
The VLAN ID for transmitting MAC-encapsulated 1588v2 packets and the 802.1p
priority of the 1588v2 packet are configured.
(Optional) Configuring the UDP encapsulation mode
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
ptp udp-egress source-ip source-ip [ destination-ip destination-ip ]
The 1588v2 packets to be sent from the interface are encapsulated in UDP
encapsulation mode, and the source and destination IP addresses are configured.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PTP Configuration
MAC Address
01-1B-19-00-00-00
01-80-C2-00-00-0E
215