Huawei Quidway S9300 Configuration Manual page 256

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
CE1
CE2
CE2
NodeB1
NodeB3
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure the IP address of each interface and enable OSPF to ensure the interworking between
devices. The configuration details are not mentioned here.
Step 2 Configure PE1 and PE2 to import BITS clock signals through their clock interfaces.
For the detailed configurations, see the section
Clock
Step 3 Configure PE1, PE2, CE1, and CE2 as BCs.
# Configure PE1.
[PE1] ptp enable
[PE1] ptp device-type bc
[PE1] clock bits-type 1pps-tod in bits0
[PE1] ptp freq-sync
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] ptp delay-mechanism pdelay
[PE1-GigabitEthernet1/0/1] ptp udp-egress source-ip 11.0.0.1 destination-ip
11.0.0.2
[PE1-GigabitEthernet1/0/1] ptp udp-egress destination-mac 1111-2222-1111
[PE1-GigabitEthernet1/0/1] ptp enable
[PE1-GigabitEthernet1/0/1] interface gigabitethernet 1/0/0
[PE1-GigabitEthernet1/0/0] ptp delay-mechanism pdelay
[PE1-GigabitEthernet1/0/0] ptp udp-egress source-ip 10.0.0.1 destination-ip
10.0.0.2
[PE1-GigabitEthernet1/0/0] ptp udp-egress destination-mac 0000-1111-2222
[PE1-GigabitEthernet1/0/0] ptp enable
[PE1-GigabitEthernet1/0/0] quit
# Configure PE2.
Issue 03 (2011-12-29)
GE1/0/1
GE1/0/0
GE1/0/1
-
-
Enable a routing protocol, that is, OSPF, to ensure the interworking between devices.
Connect PE1 and PE2 to BITS clocks.
Configure PE1, PE2, CE1, and CE2 as BCs.
Encapsulate 1588v2 packets through unicast UDP in this example.
1588 link delay measurement mechanism: Pdelay
Source.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1111-2222-1111
1111-2222-3333
1111-2222-3333
2222-3333-1111
2222-3333-2222
Example for Configuring the BITS as the PTP
12 PTP Configuration
244