Establishing The Configuration Task; Enabling The Information Center - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Context
Debugging affects the performance of the system. Thus, after debugging, run the undo
debugging all command to disable debugging immediately. When the CPU usage is close to
100%, debugging ARP may cause the board resetting. So, confirm the action before you use the
command.

5.5.1 Establishing the Configuration Task

Before configuring the debugging message output, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
When faults occur on a device, you can enable the information center to output debugging
information for easy faults location and analysis.
Pre-configuration Tasks
Before enabling the output of debugging information, complete the following tasks:
l
l
Data Preparation
To enable the output of debugging information, you need the following data.
No.
1
2
3
4

5.5.2 Enabling the Information Center

By default, the information center is enabled. You can enable the information center in the event
that the information center is disabled.
Issue 03 (2011-12-29)
CAUTION
Connecting the switch and the PC correctly
Configuring routes between the switch and the log host
Data
l Channel number
l Channel name
Module name
Severity level of debugging information
IP address of a log host
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Information Center Configuration
74