Huawei Quidway S9300 Configuration Manual page 127

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
with the 802.1p priority as 6 and the outgoing interface as GE 1/0/3 of the R&D department and
marketing department through local port mirroring. See
Figure 6-5 Networking diagram of traffic mirroring configurations
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the interface and VLAN.
<Quidway> system-view
[Quidway] sysname Switch
[Switch] vlan 2
[Switch-vlan2] quit
[Switch] interface GigabitEthernet 1/0/1
[Switch-GigabitEthernet1/0/1] port link-type trunk
[Switch-GigabitEthernet1/0/1] port trunk pvid vlan 2
Issue 03 (2011-12-29)
LSWA
R&D
department
LSWB
Marketing
department
Create a VLAN on the Switch and add GE 1/0/1, GE 1/0/2, and GE 1/0/3 to the VLAN.
Configure GE 1/0/3 as an observing port.
Create a traffic classifier and set the traffic classification rule of matching the packets with
the 802.1p priority as 6.
Create a traffic behavior and configure traffic mirroring actions in the traffic behavior.
Create a traffic policy to bind the traffic classifier and traffic behavior.
Apply the traffic policy on GE 1/0/1 and GE 1/0/2.
Name of the traffic classifier, that is, c1
Name of the traffic behavior, that is, b1
Name of the traffic policy, that is, p1
ID of the VLAN, that is, 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE 1/0/1
GE 1/0/3
Switch
GE 1/0/2
6 Mirroring Configuration
Figure 6-5.
Server
192.168.1.100
115