Configuring Ptp Globally - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Data Preparation
To configure 1588v2 on BC, you need the following data.
No.
1
2
3
4
5
6
7

12.4.2 Configuring PTP Globally

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ptp enable
1588v2 is enabled on the BC.
Step 3 Run:
ptp device-type bc
The device type is configured as BC.
Step 4 (Optional) Run:
ptp domain domain-value
The domain where the 1588v2 port resides is set.
Step 5 (Optional) Run:
ptp virtual-clock-id clock-id-value
The virtual clock ID of the BC is set.
----End
Issue 03 (2011-12-29)
Data
Number and IP address of each interface
(Optional) IDs of 1588v2 domains to which devices belong
(Optional) Asymmetric correction value of the 1588v2 packet
(Optional) Interval for sending Announce packets and the timeout period for
receiving Announce packets
(Optional) Interval for sending Sync packets
(Optional) Minimum interval for sending Delay packets
(Optional) Destination MAC address, source IP address, destination IP address,
DSCP value, VLAN ID, and corresponding priority encapsulated into the 1588v2
packet
NOTE
Clocks that need to be synchronized through 1588v2 packets must belong to the same 1588v2 clock domain.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PTP Configuration
218