Configuring Ptp Globally - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Figure 12-4 Configuring 1588v2 on OC
BITS
Pre-configuration Tasks
Before configuring 1588v2 on OC, complete the following tasks:
l
l
Data Preparation
To configure 1588v2 on OC, you need the following data.
No.
1
2
3
4
5
6
7

12.3.2 Configuring PTP Globally

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run
ptp enable
Issue 03 (2011-12-29)
Setting parameters of the link layer protocol for the interfaces and ensuring that the status
of the link layer protocol on the interfaces is Up
Ensuring that the OC1 has correctly imported the clock and time signals from the BITS
Data
Number and IP address of each interface
(Optional) IDs of 1588v2 domains to which devices belong
(Optional) Asymmetric correction value of the 1588v2 packet
(Optional) Interval for sending Announce packets and the timeout period for
receiving Announce packets
(Optional) Interval for sending Sync packets
(Optional) Minimum interval for sending Delay packets
(Optional) Destination MAC address, source IP address, destination IP address,
DSCP value, VLAN ID, and priority corresponding to the VLAN encapsulated into
the 1588v2 packet
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Master
OC1
12 PTP Configuration
Slave
OC2
211