Configuring Ptp For An Interface - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l e2etc: configures the clock mode of the device to E2ETC.
l e2etcoc: configures the clock mode of the device to E2ETCOC.
l p2ptc: configures the clock mode of the device to P2PTC.
l p2ptcoc: configures the clock mode of the device to P2PTCOC.
Step 4 (Optional) Run:
ptp domain domain-value
The domain to which the 1588v2 interface belongs is configured.
Step 5 (Optional) Run:
ptp virtual-clock-id clock-id-value
The virtual clock ID of the TC is set.
----End

12.5.3 Configuring PTP for an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ptp enable
1588v2 is enabled on the interface.
Step 4 (Optional) Run:
ptp tcoc-clock-id clock-source-id { port-num port-num | slot slot-id card card-id
port port-id }
The clock source traced by an interface on the TCOC is configured.
Step 5 (Optional) Run:
ptp asymmetry-correction { positive | negative } asymmetry-correction
The asymmetric correction time for sending 1588v2 packets on the interface is set.
Step 6 (Optional) Run:
ptp clock-step { one-step | two-step }
Issue 03 (2011-12-29)
NOTE
TCOC is a special type of TC. TCOC can also synchronize frequency with its upstream clock.
NOTE
Clocks need to be synchronized through 1588v2 packets must belong to the same 1588v2 clock domain.
NOTE
This command takes effect only on the TCOC.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PTP Configuration
225