Huawei Quidway S9300 Configuration Manual page 170

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Run the display issu backup state command to view the status of ISSU backup.
<Quidway> display issu backup state
System backup status: real-time backup
Run the display issu backup-result [ state { resource-prepare | backup-prepare | backup1
| backup2 | backup3 | smooth | smooth-all-over } ] command to view the result of ISSU backup.
<Quidway> display issu backup-result
System backup-result:
-----------------------------------------------------------------------------
State
-----------------------------------------------------------------------------
resource-prepare
backup-prepare
backup1
backup2
backup3
smooth
smooth-all-over
-----------------------------------------------------------------------------
Interface board backup-result:
-----------------------------------------------------------------------------
Slot
-----------------------------------------------------------------------------
-----------------------------------------------------------------------------
Run the display issu recover-configuration command to view the result of ISSU configuration
restoration.
<Quidway> display issu recover-configuration
---------------------------------------------------------------
Slot
Reason
---------------------------------------------------------------
9
parse failure
9
run failure
---------------------------------------------------------------
Run the display issu switch-result { check | prepare | age } command to view the result of
ISSU switch and switch preparation, and the cause of switch failure.
<Quidway> display issu switch-result check
-----------------------------------------------------------------------------
Slot
-----------------------------------------------------------------------------
8
-----------------------------------------------------------------------------
Run the display issu state command to view which ISSU phase the system passes.
<Quidway> display issu state
------------------------------------------------
Phase
------------------------------------------------
1.ISSU check
2.ISSU start
3.ISSU switchover
4.ISSU confirm
------------------------------------------------
The cancel ISSU command : issu abort.
Issue 03 (2011-12-29)
Result
success
success
success
success
success
-
-
State
ViewName
System-view
Interface Ethernet 1/0/0
Type
new AMB
State
finished
finished
finished
-
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 ISSU Configuration
Result
CommandLine
display bgp peer
display this
Result
succeeded
158