Maintaining Information Center; Information Center Configuration Examples; Example For Outputting Logs To The Log File - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
IO Reg messages = 92 IO Sent messages = 15006

5.6 Maintaining Information Center

This section describes how to run the reset info-center statistics, reset logbuffer, or reset
trapbuffer command to delete messages in the buffer of the information center. Note that deleted
messages cannot be restored.
Context
Statistics about the information center cannot be restored after being cleared. So, confirm the
action before you use the command.
Procedure
l
l
l
----End

5.7 Information Center configuration Examples

This section provides configuration of the information center.

5.7.1 Example for Outputting Logs to the Log File

This part describes how to output logs of a specific module or specific severity level to the log
file. This facilitates maintenance engineers to monitor the operating status of the device and
locate the fault occurred on the device by checking the output logs.
Networking Requirements
As shown in
server so that maintenance engineers can easily obtain the operation status of Switch A and
locate the faults occurring on Switch A.
Figure 5-4 Networking diagram of outputting logs to the log file
SwitchA
Issue 03 (2011-12-29)
CAUTION
To clear statistics about the information center, run the reset info-center statistics
command in the user view.
To clear statistics about the log buffer, run the reset logbuffer command in the user view.
To clear statistics about the alarm buffer, run the reset trapbuffer command in the user
view.
Figure 5-4, Switch A is required to transport logs to a File Transfer Protocol (FTP)
10.2.1.1/16
GE1/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IP network
FTP Server
10.1.1.1/16
5 Information Center Configuration
80