Configuring A Remote Mirrored Port; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
l To configure remote port mirroring in VLAN mode, run:
----End

6.4.3 Configuring a Remote Mirrored Port

Context
To configure an Eth-Trunk as a remote mirrored port, you must run the interface eth-trunk
trunk-id command to create the Eth-Trunk first.
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port-mirroring to observe-port observe-port-index { both | inbound | outbound }
A remote mirrored port is configured.
observe-port-index specifies the index of an observing port and must be the same as the index
of an observing port in
----End

6.4.4 Checking the Configuration

Prerequisite
The configurations of port mirroring are complete.
Procedure
l
Issue 03 (2011-12-29)
observe-port [ observe-port-index ] interface interface-type interface-number
destination-ip dest-ip-address source-ip source-ip-address [ dscp dscp-value |
*
vlan vlan-id ]
observe-port [ observe-port-index ] interface interface-type interface-number
vlan vlan-id
NOTE
Do not perform other configurations on an observing port; otherwise, the mirroring function is affected.
If an Eth-Trunk is configured as a mirrored port, its member interfaces cannot be configured
as mirrored ports.
If a member interface of an Eth-Trunk is configured as a mirrored port, the Eth-Trunk
cannot be configured as a mirrored port.
6.4.2 Configuring a Remote Observing
Run the display observe-port command to check the observing port in port mirroring.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Mirroring Configuration
Port.
103