Advanced Occupied/ Unoccupied Selection - Honeywell TR80 Installation And Operating Manual

2.7.2 Advanced Occupied/ unoccupied selection

In this mode, occupancy status is set by the master controller by considering vari-
ous factors like time schedule, motion sensor, a key-card system etc.
The various possible occupancy status are indicated on the screen as shown in the
below table.
Occupancy Status
Occupied
Unoccupied
Standby
Bypass
TR80 - Installation and Operation Guide
Description
Room is occupied and would typically operate in comfort mode.
The display will show occupancy symbol at the right bottom corner.
Room is unoccupied would typically operate in a building protection mode.
The display shows unoccupied symbol with text" AWAY".
Room is not occupied yet, it is kept in ready to occupy condition.
The display shows unoccupied symbol with scrolling text "STAND BY".
The user has overridden the automatic mode and switched the system to
comfort mode temporarily.
The display shows occupied symbol with scrolling text "Comfort for ... mins"
23