Maintaining Vpls; Collecting The Statistics Of The Traffic On A Vpls Pw - Huawei Quidway S9300 Configuration Manual

6 VPLS Configuration
The MPLS L2VPN view is displayed.
Step 3 Run:
vpls pw-down-delay pw-down-delay-time
The number of times that the system delays processing the VPLS PW Down event is configured.
----End
Postrequisite
In the case of a multi-homed CE, the vpls pw-down-delay command does not need to be run
on the PEs. That is, the default value 0 is adopted. In the case of a non-multi-homed CE, you
are recommended to run the vpls pw-down-delay command on the PEs and set the number of
delay times of VPLS PW Down to non-zero (the recommended value is 5). This can greatly
improve the convergence performance of the VPLS.
After the vpls pw-down-delay command is run, the delay for the system to process the PW
Down event is determined by the number of PWs and the number of times that the system delays
processing the VPLS PW Down event on the device.

6.10 Maintaining VPLS

This section describes how to maintain VPLS.

6.10.1 Collecting the Statistics of the Traffic on a VPLS PW

6.10.2 Checking the Traffic on a VPLS PW
6.10.3 Resetting Traffic Statistics
6.10.4 Debugging VPLS
6.10.5 Enabling or Disabling a VSI
6.10.6 Clearing MAC Address Entries
6.10.1 Collecting the Statistics of the Traffic on a VPLS PW
Context
Do as follows on the VPLS device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
6-34
NOTE
If a carrier needs to establish a model of the traffic between IP MANs and between MPLS core MANs for
the reference of Diff-serv TE deployment and maintenance, or the carrier needs to charge the non-monthly
rental subscribers based on traffic, you can collect the statistics of the traffic on a specified PW.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Issue 03 (2009-08-20)