Checking Power Steering Fluid - Toyota 4-Runner-U 2006 Manual

WWW.MANUALS.WS
Refilling brake fluid:
1. Turn the ignition switch off.
2. Depress the brake pedal more than 20
times (until the brake pedal resistance
decreases and pedal travel increases).
3. Remove the reservoir cover by hand.
Add brake fluid up to the "MAX" line.
If you do not follow the procedure above,
the reservoir may overflow.
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
CAUTION
Take care when filling the reservoir
because brake fluid can harm your
hands or eyes. If fluid gets on your
hands or in your eyes, flush the af-
fected area with clean water immedi-
ately. If you still feel uncomfortable
with your hands or eyes, go to the
doctor.
424
WWW.MANUALS.WS
'06 4Runner_U (L/O 0508)
NOTICE
If you spill some of the fluid, be sure
to wipe it off to prevent it from dam-
aging the parts or paintwork.

Checking power steering fluid

If cold O.K.
If hot O.K.
Close
Open
If cold
add
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRONRII or III.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60AC—80AC or 140AF—175AF). You
may also check the level when the fluid
is cold (about room temperature,
10AC—30AC or 50AF—85AF) if the engine
has not been run for about five hours.
If hot
add