Cylinder Head Covers - Suzuki 2000 Grand Vitara SQ625 Service Manual

6A2-18 ENGINE MECHANICAL (H25 ENGINE)
Left (No.1) cylinder
Area to apply sealant "A"
Right (No.2) cylinder
Area to apply sealant "A"
1. Cylinder head cover
3. Seal washer
2. Nut 4. Cylinder head cover gasket

CYLINDER HEAD COVERS

REMOVAL
1) Remove throttle body and intake manifold.
2) Remove ignition coil covers.
3) Disconnect ignition coil couplers and remove ignition coils.
4) Remove cylinder head covers.
1. Cylinder head cover
2. Nut
3. Seal washer
4. Cylinder head cover
gasket
INSTALLATION
1) Clean sealing surfaces on cylinder heads and covers.
2) Remove oil, old sealant, and dust from sealing surfaces. After
3) Install new cylinder head cover gaskets to head covers.
4) Install cylinder head covers to cylinder heads.
5) Using new seal washers, tighten nuts to specified torque.
6) Install ignition coils and connect ignition coil couplers.
7) Install ignition coil covers.
8) Install throttle body and intake manifold.
Refer to item "THROTTLE BODY AND INTAKE MANIFOLD" in
this section for removal.
cleaning, apply sealant "A" to cylinder heads sealing surface
area as shown in figure.
"A": Sealant 99000-31150
Tightening Torque
.
(a): 10.5 N m (1.1 kg-m, 7.5 lb-ft)
Refer to item "THROTTLE BODY AND INTAKE MANIFOLD" in
this section for installation.