Suzuki 2000 Grand Vitara SQ625 Service Manual page 284

6A1-42 ENGINE MECHANICAL (G16 ENGINE)
5) Remove air intake hose.
6) Disconnect following electric wires:
D Throttle position sensor
D Idle air control valve
D Engine coolant temp. sensor
D Camshaft position sensor
D Ground wires from intake
manifold
D EGR valve
and then release above wire harnesses from clamps.
7) Disconnect following hoses:
D EVAP canister purge hose from EVAP canister purge valve
D Brake booster hose from intake manifold
D Engine coolant hose (outlet side) from throttle body
D Radiator inlet hose from thermostat cap
D Heater inlet hose from pipe
D Fuel feed hose and return hose from each pipe
D Vacuum hose from intake manifold
8) Disconnect accelerator cable and A/T throttle cable (if
equipped) from throttle body.
9) Remove cylinder head cover as previously outlined.
Loosen all valve lash adjusting screws fully.
10) Remove timing belt and camshaft as previously outlined.
11) Remove generator adjust arm from intake manifold.
12) Remove air conditioning compressor adjust arm from cylinder
head. (if equipped)
D Manifold differential
pressure sensor
D EVAP canister purge valve
D Injector wires at the
coupler
D Heated oxygen sensor-1