Suzuki 2000 Grand Vitara SQ625 Service Manual page 722

1. Rectifier insulators
1. Rectifier
Upward
1. Rear end cover
2. Insulator
3. "B" terminal inner nut
4. Terminal plate (85 A type only)
10) Install 4 rubber insulators.
11) Install rectifier.
Tightening Torque
(a): 2.0 N
(b): 3.9 N
12) Install brush holder cover to brush holder.
13) Place the IC regulator together with the brush holder horizon-
tally on the rear end frame.
14) Install the 5 screws until there is a clearance of approx. 1 mm
(0.04 in.) between the brush holder and connector.
Approx.
1 mm
Tightening Torque
(a): 2.0 N
1. IC regulator
2. Brush holder
3. Rear end frame
15) Install rear end cover and terminal plate.
Tightening Torque
(a): 4.5 N
(b): 3.8 N
16) Install insulator and tighten "B" terminal inner nut to specified
torque.
Tightening Torque
(c): 4.2 N
CAUTION:
When installing rectifier, check to confirm that stator
leads have enough clearance with cooling fan blades.
.
m (0.2 kg-m, 1.5 lb-ft)
.
m (0.39 kg-m, 3.0 lb-ft)
.
m (0.2 kg-m, 1.5 lb-ft)
.
m (0.45 kg-m, 3.5 lb-ft)
.
m (0.38 kg-m, 3.0 lb-ft) (85 A type only)
.
m (0.42 kg-m, 3.0 lb-ft)
CHARGING SYSTEM 6H-29