Suzuki 2000 Grand Vitara SQ625 Service Manual page 489

6A4-70 ENGINE MECHANICAL (J20 ENGINE)
23) Remove bolt and nuts fastening cylinder block and transmis-
sion.
24) Install lifting device.
25) Remove engine side mounting bracket nuts from engine
mountings.
26) Before lifting engine, check to ensure all hoses, wires and
cables are disconnected from engine.
27) Remove engine assembly from chassis and transmission by
lifting a little, sliding toward front, and then, carefully hoist en-
gine assembly.
INSTALLATION
Reverse removal procedure for installation, noting following points.
1) Lower engine assembly into engine compartment. Connect en-
gine to transmission and engine side mounting brackets to en-
gine mountings.
2) Tighten nuts fastening engine side mounting brackets and en-
gine mountings.
Tightening Torque
.
(a): 50 N m (5.0 kg-m, 36.5 lb-ft)
3) Tighten bolt and nuts fastening cylinder block and transmission
to specified torque.
Tightening Torque
.
(a): 85 N m (8.5 kg-m, 61.5 lb-ft)
4) Remove lifting device.